Onboarding New MWS with MillMax

---

This is the document that was received by other MWS when the MillMax kits were first distributed. Please review as it may answer some questions you may have:

As soon as we are notified, you will receive an email that will enable you to setup a password to enter the secured portions of this taptest.co website. When you log in you will see a link to your kit's home page (taptest.co/your kit's number). If you have not received this email, please contact me  at barton.dave@me.com

​Click on that link and perform the instructions on the following page AS SOON AS YOU RECEIVE YOUR KIT:
mli.supportbee.io/2770-millmax-support-center/6052-installing-millmax/19119-installing-or-updating-sensor-file
If you do not have the correct calibration file for your kit your measurements will not be accurate!

When you receive your kit, check to make sure it has all of its components by CLICKING HERE

Request a training stand from your manager. There are 12 of them in the field. 

Once you complete the training on MyMSC, you can access those lessons for review, plus additional advanced tips and training (including how to use the above stand) by clicking this link: taptest.co/training (password required).

While we welcome any questions, the answer to every question or service request we have received to date has been recorded on this searchable site:
https://mli.supportbee.io/2770-millmax-support-center